JetPro® SS (Sofstretch™)  Inkjet Printable Transfer Paper

JetPro® SS (Sofstretch™) Inkjet Printable Transfer Paper

  • $1.75
Shipping calculated at checkout.


Neenah JetPro® SS transfer paper is designed  to transfer inkjet photo-quality images and graphics onto light-colored materials.  The result is a very soft stretchable transfer that won't crack when fabric is stretched. It is durable and able to withstand many laundry cycles.

This product is printable by most desktop and roll fed inkjet printers. 

Store Heat Transfer Paper in a cool, dry area in a poly bag and do not remove until you are ready to use

Watch this video for helpful instruction and tips.  After the introduction the JetPro SS instructions begin at the 1:00 mark.

 

 Printing Instructions:

  • Mirror image your artwork. Single-sheet feeding is recommended.

  • Set printer for normal image quality (do NOT over saturate with ink).
  • Print your image on the white imaging side of the sheet (not the side with gridlines).

Application instructions (home iron)

  • Trim your printed design to remove any unprinted area if desired. For best results (optional), use a design with rounded edges to avoid corner lift-off after washing
  • Place design image side down on garment.
  • Preheat iron  to highest setting (no steam).
  • Cover design with Kraft paper or non-stick cover sheet
  • Place on flat, hard surface (ironing board not recommended)
  • Using two hands and heavy pressure, slide the iron up and down (vertically) over the entire image for 90 seconds, then repeat side to side (horizontally) for 90 seconds.
  • Peel carrier warm approx 2 min after completing
  • While fabric is still hot, quickly stretch the fabric in all directions for greatest softness.

Application Instructions (heat press)

  • Trim Your Printed Design If Desired
    Before transferring, cut as close to the image as possible, leaving no margin. For best results (optional), use a design with rounded edges to avoid corner lift-off after washing
  • Place design image side down on garment.
  • Preheat garment for 2-3 seconds. 
  • Apply design 30 seconds at 375°F/17790°C using medium/heavy pressure (30 psi/3-5 bar)
  • Allow to cool slightly to avoid burning fingers and peel carrier.
  • While fabric is still hot quickly stretch the fabric in all directions for greatest softness.

Applies to:

100% cotton
Poly/cotton blends
100% polyester

Laundering:

  • Wait 24 hrs after application before first wash.
  • Turn garment inside out and wash in cold water using a mild detergent.
  • Do not use bleach or liquid fabric softener
  • Dry on low-heat setting.
  • If you intend to iron the transferred area, ensure that the image is covered with parchment paper before ironing.